One among the easiest ways to lower the quantity of electricity that you utilize in your house is to turn off lights and appliances when you aren’t using them. That being said, this is something that many homeowners find easier said than done. Luckily for you, there are a wide range of devices available now that may help you in your try and shut off all devices when not in regular use. Options range from simple power strips, to timed lights and outlets to smart strips that turn all the best way off when reduced electrical current is detected. One very handy way to control lighting in a certain area is with a motion sensor light switch. This enables you to simply turn lights on and off whenever someone enters and leaves a room. Follow these steps to install one.
Step 1: Shut Off Power
Because you’re dealing with electrical components, you will have to find out which circuit breaker controls this particular switch and shut it off at the electrical panel. If you’re worried about someone coming along and flipping that breaker back on before you might be finished, tape over the breaker and leave a sign that claims “don’t touch!”
Step 2: Remove the Old Switch and Test the Wires
Start by taking the wall plate off of the current switch and testing the wires with a circuit tester. This may ensure that there is certainly no power running through this particular circuit. If you’re using an audible tester, a continuous beep typically indicates that there remains to be power. Your tester should confirm your belief that the circuit has been shut off. Now you can remove the screws holding the switch in its box and pull it out.
Step 3: Disconnect Wires
Your old switch should have three different wires connected to it: a black wire, a bare ground wire and a white wire. You will have to use the black and white wires with the motion sensor switch, but not the ground. Disconnect or cut these wires at the back of your old switch. It’s best to then strip the wires to permit for proper connectivity to the brand new motion-sensor switch.
Step 4: Connect Your New Switch
Now that you’ve stripped your wires, you can connect them to your new switch. Start by wrapping the black wire snugly around the appropriate wire connection on the back of the switch. Do the same with the white wire and secure them with wire connectors.
Step 5: Insert The Switch
After everything has been connected, tuck the switch back into the box. You may then secure it with the provided screws.
Step 6: Customize and Enjoy
After your switch has been installed, you may spend just a little time customizing it so that it provides the extent of sensitivity that you’re looking for. When properly adjusted, your motion sensor light should trigger your lights on whenever someone enters the room. It will then shut the sunshine off after a given time frame, as long as no new motion is sensed.